be clean and grease-free. Apply spray
adhesive thinly and evenly from a distance
of approx. 25 cm to both sides. Allow
adhesive surfaces to dry out for at least
10 minutes, then put together and apply
pressure.
do not use if temperature is below 5°C.
with the accompanying
hardener
sealing pipes and tanks, attaching screws
and hooks, renewing defective threads,
compensating for unevenness, plugging
holes, etc.
components together until a homogeneous
green kneadable compound is produced.
Then use within 15 minutes. The areas to
be repaired must be clean and free of oil
and grease.
stroke and 4-stroke petrol and diesel
engines. Successful starts, particularly in
the wet or cold. Ideal for engines with a
cord-pull starter.
intake and start.
if attempts at starting are unsuccessful
(too much fuel in the engine), before
using K(W)ICK START first start several
times with the throttle valve open (e.g.
accelerator pedal depressed). Then apply
K(W)ICK START.
outstanding adhesion to metal, wood, glass,
plastic.
single work stage to a depth of 20 mm.
Clean surface to remove grease, roughen
up slightly, and apply METAPLAST.
Metaflux 70-65 Galvaplast